Mitsubishi Electric MELSEC iQ-R Series User Manual page 153

CH1 Input value shift amount
The set value is added to the digital input value regardless of the on/off status of 'Operating condition setting request' (Y9).
For the shift function, refer to the following.
Page 26 Shift Function
■Buffer memory address
The following shows the buffer memory address of this area.
Buffer memory name
CH Input value shift amount
CH Input value shift amount (When the Q
compatible mode function is used)
■Setting range
The setting range is from -32768 to 32767.
■Default value
The default value is 0 for all channels.
CH1 Wave output step action movement amount
This area is for setting the wave output step action movement amount and for checking if the target has been obtained.
The value set in this area is subtracted from or added to the buffer memory address that has been storing the value and so the
buffer memory address of Wave data registry area that has been storing the target digital value is specified. When a value is
set in this area, the target address starts to be specified and when specifying the address is complete, No movement (0) is
stored.
The setting for this area is enabled only when the following conditions are satisfied.
• In the wave output mode
• When During wave output step action (3) is stored in 'CH1 Wave output status monitor' (Un\G401).
Movement direction
No movement
Forward movement (movement in the direction to increase the address)
Reverse movement (movement in the direction to decrease the address)
The setting range is from -30000 to 30000. Even if a set value is out of the setting range, no error occurs. When a value
smaller than -30000 is set, the value is processed as -30000. When a value greater than 30000 is set, the value is processed
as 30000.
The following shows the available range for movement.
• "Wave pattern start address" to "Wave pattern start address" + "Wave pattern data points setting" - 1
If a value equal to or more than the wave pattern data points is set, only the data for the wave pattern data points is
processed.
Set a value for the wave output step action movement amount. When specifying the address is complete, No movement (0) is
stored in this area.
■Buffer memory address
The following shows the buffer memory address of this area.
Buffer memory name
CH Wave output step action movement
amount
CH Wave output step action movement
amount (When the Q compatible mode function
is used)
■Default value
The default value is No movement (0) for all channels.
CH1 CH2 CH3
480 680 880
150 151 152
Setting value
0
1 to 30000
-30000 to -1
CH1 CH2 CH3
482 682 882
1080 1081 1082
CH4 CH5 CH6
1080 1280 1480
153 154 155
CH4 CH5 CH6
1082 1282 1482
1083 1084 1085
Appendix 3 Buffer Memory
CH7 CH8
1680 1880
156 157
A
CH7 CH8
1682 1882
1086 1087
APPENDICES
151