Mitsubishi Electric MELSEC iQ-R Series User Manual page 53

Parameter setting of the D/A converter module
1
To use the wave output function, the module parameters are required in addition to the parameter setting of the wave output
function.
The following shows the items set with the module parameters.
■Output range setting
"Output range setting" is the same as the one for the normal output. Select the output range to be used.
However, the user range cannot be used when the wave output function is used.
■Operation mode setting
Select "Normal mode (D/A conversion process)" in "Operation mode setting".
■Output mode setting
Select "Wave output mode" in "Output mode setting".
■Analog output HOLD/CLEAR setting
The operation of the analog output HOLD/CLEAR function for the normal output differs from the operation for the wave output.
For the difference of the operations performed depending on the setting details of the HOLD/CLEAR setting, refer to the
following.
Page 20 Analog Output HOLD/CLEAR Function
■Alert output setting
Set "Alert output setting" for "Enable" of the channel where the D/A conversion is performed, as the normal output.
For the normal output, 'CH1 Digital value (Un\G460)' is the target. However, for the wave output, the set wave output data is
the target.
1 FUNCTIONS
51
1.14 Wave Output Function