Siemens SINUMERIK 840DE sl Commissioning Manual page 112

8 Tool Management
8.10 Configuring the operator interface
ID
8-112
Next define the changes themselves:
S
Modify a specific column for all tools:
COLUMNx=CONTENTS_IDENTIFIER
COLUMN: Column command
x: Column number, 1 – 12
CONTENTS_IDENTIFIER: Parameter or property of tool
S
Modify a specific column for a specific tool:
TOOL_IDENTIFIER = x=CONTENTS_IDENTIFIER
TOOL_IDENTIFIER: Tool type
S
Define different columns for each tool:
TOOL_IDENTIFIER = CONTENTS_IDENTIFIER / CONTENTS_IDEN-
TIFIER / ...
TOOL_IDENTIFIER = CONTENTS_IDENTIFIER / CONTENTS_IDEN-
TIFIER / ...
...
The parameters or properties of a tool are listed one after the other by
means of a CONTENTS_IDENTIFIER and are separated from one another
by a slash "/". If the default setting is to be used for individual columns, you
still need to insert a forward slash.
If, for example, you only want to modify the last few columns, specify the
number (x) of the first column you would like to modify and list the respective
CONTENTS_IDENTIFIERs for the subsequent columns.
TOOL_IDENTIFIER = x=CONTENTS_IDENTIFIER / CONTENTS_IDEN-
TIFIER / ..
Note
Using the COLUMN command, you can first define one column identically for
all tools and then adapt it specifically for individual tools.
You can mark comments by means of a semicolon (;) symbol.
If errors occur during evaluation of the configuration file, refer to the
TO_INI_F.LOG file for a description of the error. For the ShopMill on NCU (HMI
Embedded) version, the file is located on drive I:, for PCU 50.3 in the directory
F:\MMC0W32\TMP.
The following tables list the SCREEN_ IDENTIFIERS, TOOL_ IDENTIFIERS,
and CONTENTS_ IDENTIFIERS available for defining the columns.
Table 8-6 SCREEN_IDENTIFIER
SCREEN_IDENTIFIER
TOOL_LIST
TOOL_LIST_2ND_EDGE
TOOL_WEAR
TOOL_WEAR_2ND_EDGE
TOOL_MAGA
TOOL_LIST_OEM
TOOL_LIST_OEM_2ND_EDGE
SINUMERIK 840D sl Commissioning Manual CNC: ShopMill – 11/2006 Edition
Tool management list
Tool list
Tool list, further cutting edges
Tool wear list
Tool wear list, further cutting edges
Magazine list
Additional list
Further cutting edges
© Siemens AG 2006 All Rights Reserved
11/2006