Siemens SINUMERIK 840DE sl Commissioning Manual page 173

11/2006
"High Speed
Settings" cycle
© Siemens AG 2006 All Rights Reserved
SINUMERIK 840D sl Commissioning Manual CNC: ShopMill – 11/2006 Edition
Table 11-3 Machine–specific machine data
Channel–specific MD/SD
20600 $MC_MAX_PATH_JERK
20602 $MC_CURV_EFFECT_ON_PATH_ACCEL
20603 $MC_CURV_EFFECT_ON_PATH_JERK
Axis– and drive–specific MD/SD
32200 $MA_POSCTRL_GAIN[n]
32300 $MA_MAX_AX_ACCEL
32431 $MA_MAX_AX_JERK
32432 $MA_PATH_TRANS_JERK_LIM
32433 $MA_SOFT_ACCEL_FACTOR
32434 $MA_G00_ACCEL_FACTOR
32435 $MA_G00_JERK_FACTOR
32810 $MA_EQUIV_SPEEDCTRL_TIME[n]
1004 $MD_CTRL_CONFIG = 1000
1407 $MD_SPEEDCTRL_GAIN_1[n]
1409 $MD_SPEEDCTRL_INTEGRATOR_TIME_1[n]
1414 $MD_SPEEDCTRL_REF_MODEL_FREQ
1500 $MD_NUM_SPEED_FILTERS[n]
1501 $MD_SPEED_FILTER_TYPE[n]
1503 $MD_SPEED_FILTER_2_TIME[n]
The optimal velocity control for machining is configured within the mold making
program with the "High Speed Settings" cycle (CYCLE 832). The cycle is sup-
plied with ShopMill.
You must preconfigure the cycle; in other words, you must set the parameters in
advance depending on the machining type (roughing, rough finishing, finishing).
In addition, you can also undertake machine–specific adaptation of the "High
Speed Settings" cycle in order to further optimize the processing of the mold
making program. The "CYC_832T" cycle is available for this.
Note
The "High Speed Settings" cycle is merely used for setting the NCK functions
for the velocity control, i.e. the optimization of drives described above is a
requirement for it.
The "High Speed Settings" cycle can be called via the cycle support in the
G-code editor of ShopMill.
More detailed information about the cycles "High Speed Settings" and
"CYC_832T" can be found in:
References: /PGZ/,
11 Miscellaneous
11.8
Programming Guide Cycles
Mold making
11-173