Measuring Cycle Support In The G Code Editor - Siemens SINUMERIK 840DE sl Commissioning Manual

11/2006
9.6

Measuring cycle support in the G code editor

ShopMill on NCU
(HMI Embedded)
© Siemens AG 2006 All Rights Reserved
SINUMERIK 840D sl Commissioning Manual CNC: ShopMill - - 11/2006 Edition
9.6
In ShopMill you can integrate screen forms which provide support for program-
ming measuring cycles into the G code editor. These cycles can then be recom-
piled automatically.
The "measuring cycles" function is a software option with
Order No. 6FC5 800--0AP28--0YB0.
For more information on measuring cycle support please refer to:
References: /BNM/, Measuring Cycles User Manual
For startup proceed as follows:
Remove the semicolon ";" preceding the following line in the file
S
STANDARD_CYCLES\COMMON.COM:
;sc8407=aeditor.com
This creates the link between the softkey, with which you call the measuring
cycle support, and the configuration file of this support mask.
Remove the semicolon ";" preceding the following line in file
S
STANDARD_CYCLES\COMMON.COM:
;sc617=startup.com
You can modify the characteristics of the measuring cycle support in the
startup operating area.
S Restart the machine.
S If required, modify the characteristics for the measuring cycle support in the
"Startup" → ">" → "Measuring cycles" menu.
Measuring cycle support in the G code editor
;Milling measuring cycles (horizontal softkey 7
;on the expanded softkey bar in the
;G--code editor)
;Startup operating area (horizontal
;softkey 7 on the expanded softkey bar)
9 Additional Functions
9-143