Configuring The Operator Interface - Siemens SINUMERIK 840DE sl Commissioning Manual

11/2006
8.10

Configuring the operator interface

8.10.1 Integrating additional list
© Siemens AG 2006 All Rights Reserved
SINUMERIK 840D sl Commissioning Manual CNC: ShopMill – 11/2006 Edition
There are two ways you can modify the existing operator interface for the tool
management system:
S
In tool management, in addition to the tools, wear, and magazine lists, an
additional list can also be activated on the 3rd horizontal softkey; (see sec-
tion 8.10.1 "Integrating additional list").
S
Dependent upon the tool, you can configure the existing or user–defined
parameters in the lists (see chapter 8.10.2 "Configuring lists").
If you want to activate an additional list or change the lists, proceed as follows:
S
Setting machine data
9478 $MM_TO_OPTION_MASK, bit 2=1
Activate additional list
You can now call up a list with the following parameters in the tool manage-
ment using the 3rd horizontal softkey:
– "LROU"
– "Location type"
S
Specifying texts for additional list (optional)
If you want to change the softkey label (OEM tool list) and header (OEM tool
list) of the additional list, you must define new texts (see chapter 8.10.7 "De-
fining texts").
8 Tool Management
8.10 Configuring the operator interface
8-109