11/2006
Example
© Siemens AG 2006 All Rights Reserved
SINUMERIK 840D sl Commissioning Manual CNC: ShopMill – 11/2006 Edition
The H number for ISO dialect programs is only analyzed if
ShopMill is configured for ISO dialects (see chapter 11.2 "ISO dialects").
If you do not define parameters, tool management will subsequently set them to
zero.
You must program the command "M30" at the end of the file.
Notes about loading the tool data into the tool management can be found in:
References:
/BASsl/, Operating/programming ShopMill
;TOOL MAGAZIN ZEROPOINT,TOOL=2,MAGAZIN=0,NPV=0,BNPV=0
$TC_TP1[1]=1
$TC_TP2[1]=FRAESER
$TC_TP3[1]=1
$TC_TP4[1]=1
$TC_TP5[1]=1
$TC_TP6[1]=1
$TC_TP7[1]=1
$TC_TP8[1]=2
$TC_TP9[1]=1
$TC_DP1[1,1]=120
$TC_DP3[1,1]=120.41
$TC_DP6[1,1]=5
$TC_DP24[1,1]=3
...
M30
8 Tool Management
8.11
Importing tool data
;Duplo number
;Tool "mill"
;Left adjacent location free
;Right adjacent location free
;Upper adjacent location free
;Lower adjacent location free
;Magazine location type
;Enable tool
;Tool life monitoring
;Tool type end mill
;Length
;Radius
;Number of teeth
;End of program
J
8-125