Siemens SINUMERIK 840DE sl Commissioning Manual page 54

7 Machine Data
7.2 Display machine data for ShopMill
9653
MD number
Default setting: 0
Change becomes effective after: IMMEDIATELY
Data type: BYTE
Significance:
9654
MD number
Default setting: 0
Change becomes effective after: IMMEDIATELY
Data type: BYTE
Significance:
9655
MD number
Default setting: –1
Change becomes effective after: IMMEDIATELY
Data type: DOUBLE
Significance:
9656
MD number
Default setting: –1
Change becomes effective after: IMMEDIATELY
Data type: DOUBLE
Significance:
9657
MD number
Default setting: 5
Change becomes effective after: IMMEDIATELY
Data type: WORD
Significance:
7-54
$MM_CMM_ENABLE_A_AXIS
Enable 4th axis for operator interface
Min. input limit: 0
Protection level: 3/4
4. Enable 4th axis (e.g. A axis) for operator interface:
0 = 4th axis is not displayed on the operator interface
1 = 4th axis is displayed on the operator interface
2 = 4th axis is displayed on the operator interface and can be programmed
3 = 4th axis is displayed on the operator interface only for reference point approach
$MM_CMM_SPEED_FIELD_DISPLA Y_RES
Number of decimal places in the speed input field
Min. input limit: 0
Protection level: 3/4
This MD is used to stipulate the number of decimal places in parameter field S (speed).
$MM_CMM_CYC_PECKING_DIST
Retraction distance for deep hole drilling
Min. input limit: –1
Protection level: 3/4
This MD is used to determine the retraction distance for deep hole drilling with chip break-
ing.
Note:
–1 means that the value for the retraction distance can be entered on the operator interface
(parameter "V2", return distance).
$MM_CMM_CYC_DRILL_RELEASE_DIST
Retraction distance for boring
Min. input limit: –1
Protection level: 3/4
This MD is used to determine the distance by which the tool moves free in X and Z direc-
tion for boring.
Note:
–1 means that the value of the retraction distance D can be entered on the operator inter-
face.
$MM_CMM_CYC_MIN_CONT_PO_T O_RAD
Variation of smallest possible cutter radius in %
Min. input limit: 0
Protection level: 3/4
This MD is required for milling contour pockets. This parameter is used to stipulate the
percentage by which the radius of the cutter being used may be smaller than the one used
for generation.
SINUMERIK 840D sl Commissioning Manual CNC: ShopMill – 11/2006 Edition
Max. input limit: 3
Units: –
Valid as of software version
ShopMill 4.3
Max. input limit: 4
Units: –
Valid as of software version
ShopMill 4.3
Max. input limit: 100.0
Units: mm
Valid as of software version
ShopMill 4.3
Max. input limit: 10.0
Units: mm
Valid as of software version
ShopMill 4.3
Max. input limit: 50
Units: %
Valid as of software version
ShopMill 4.3
© Siemens AG 2006 All Rights Reserved
11/2006