Siemens SINUMERIK 840DE sl Commissioning Manual page 34

6 Signal Description
6.3 Overview of the former ShopMill interface
Address
DB82
DBX
9.1 CMM_IN.spindle_start
Spindle start
9.2 CMM_IN.spindle_stop
Spindle stop
9.3 CMM_IN.spindle_left
Spindle start
9.4 CMM_IN.spindle_right
Spindle start
9.5 CMM_IN.program_extern_selected
Program is selected in the PLC.
9.6 CMM_IN.disable_cnc_standard
Locking switchover to CNC–ISO user inter-
face
9.7 CMM_IN.cmm_activ_in_cnc_mode
ShopMill PLC active during CNC–ISO oper-
ation
10.0 CMM_IN.program_test_request
Select function for program test
10.1 CMM_IN.dry_run_request
Select DryRun function
10.2 CMM_IN.m01_request
Select function M01
10.3 CMM_IN.skip_block_request
Select function for skipping record
10.4 CMM_IN.boot_standard
System boot in CNC–ISO user interface
10.5 CMM_IN.nck_auto_req
Prepare record search PLC
10.6 CMM_IN.spindle_act_m30_reset
Spindle active after M30 and reset
10.7 CMM_IN.ignore_nck_alarm
Ignore NCK alarm in the event of cycle start
11.1 CMM_IN.get_tool_data
Update tools data
6-34
Name
Comments
SINUMERIK 840D sl Commissioning Manual CNC: ShopMill – 11/2006 Edition
Spares
Standard interface DB3x.DBX30.1/30.2
Standard interface DB3x.DBX30.0
Standard interface DB3x.DBX30.2
Standard interface DB3x.DBX30.1
No longer required due to updated logic in Shop-
Mill interface.
ShopMill Open (PCU 50.3):
not available;
ShopMill on NCU (HMI Embedded):
lock for the remaining operating areas by means
of protective levels
Omitted since ShopMill PLC no longer exists
MMC –> PLC DB21.DBX25.7
PLC –> NCK DB21.DBX1.7
Connect as in the PLC user program.
MMC –> PLC DB21.DBX24.6
PLC –> NCK DB21.DBX0.6
Connect as in the PLC user program.
MMC –> PLC DB21.DBX24.5
PLC –> NCK DB21.DBX0.5
Connect as in the PLC user program.
MMC –> PLC DB21.DBX26.0 ff
PLC –> NCK DB21.DBX2.0 ff
Connect as in the PLC user program
ShopMill Open (PCU 50.3):
Change PoweronTask in control, or remove Shop-
Mill operating area from the control, or assign pro-
tective levels to the ShopMill operating areas in
the control;
ShopMill on NCU (HMI Embedded):
Assign a protective level to the ShopMill operating
area
Omitted since operating area jog, automatic and
MDA are now identical to the NCK modes
Omitted since ShopMill PLC no longer exists
Omitted since the NC start of ShopMill is no longer
manipulated
Omitted since the NC start of ShopMill is no longer
manipulated
© Siemens AG 2006 All Rights Reserved
11/2006