Toshiba ACE-tronics G9 ASD Installation And Operation Manual page 144

F271
Jump Frequency 1 Bandwidth
Program  Special  Jump Frequencies
This parameter establishes a plus-or-minus value for Jump Frequency 1 (see
F270).
Jump Frequency 2
Program  Special  Jump Frequencies
Same as Jump Frequency 1 (F270) and is used when multiple frequencies are
to be jumped (see the plus-or-minus value setting at F273). When multiple
jump frequencies overlap, the system will recognize the lowest and the highest
frequencies as one jump range.
Jump Frequency 2 Bandwidth
Program  Special  Jump Frequencies
This parameter establishes a plus-or-minus value for Jump Frequency 2
(F272).
Jump Frequency 3
Program  Special  Jump Frequencies
Same as Jump Frequency 1 (F270) and is used when multiple frequencies are
to be jumped (see the plus-or-minus value setting at F275).
When multiple jump frequencies overlap, the system will recognize the lowest
and the highest frequencies as one jump range.
Jump Frequency 3 Bandwidth
Program  Special  Jump Frequencies
This parameter establishes a plus-or-minus value for Jump Frequency 3
(F274).
134
Buy: www.ValinOnline.com | Phone 844-385-3099 | Email: CustomerService@valin.com
Direct Access Number — F271
Parameter Type — Numerical
Factory Default — 0.00
Changeable During Run — Yes
Minimum — 0.00
Maximum — 30.00
Units — Hz
Direct Access Number — F272
Parameter Type — Numerical
Factory Default — 0.00
Changeable During Run — Yes
Minimum — 0.00
Maximum — Max. Freq. (F011)
Units — Hz
Direct Access Number — F273
Parameter Type — Numerical
Factory Default — 0.00
Changeable During Run — Yes
Minimum — 0.00
Maximum — 30.0
Units — Hz
Direct Access Number — F274
Parameter Type — Numerical
Factory Default — 0.00
Changeable During Run — Yes
Minimum — 0.00
Maximum — Max. Freq. (F011)
Units — Hz
Direct Access Number — F275
Parameter Type — Numerical
Factory Default — 0.00
Changeable During Run — Yes
Minimum — 0.00
Maximum — 30.0
Units — Hz
ACE-tronics G9 ASD Installation and Operation Manual
F275