Toshiba ACE-tronics G9 ASD Installation And Operation Manual page 63

EOI Command Mode
The EOI Command mode is accessed by pressing the ESC key from the Frequency Command screen.
The control settings of the EOI Command menu are effective for EOI control only.
The EOI Command mode provides quick access to the following menu parameters:
Direction — Forward or Reverse.
Stop Pattern — The Decel Stop or Coast Stop settings determines the method used to stop the
motor when using the Stop-Reset key of the EOI. The Decel Stop setting enables the Dynamic
Braking system setup at
The Coast Stop setting allows the motor to stop at the rate allowed by the inertia of the load.
Note: The Stop Pattern setting has no effect on the Emergency Off settings of F603.
V/f Group — One of four V/f profiles may be selected and run. Each V/f profile is comprised of 4
user settings: Base Frequency, Base Frequency Voltage, Manual Torque Boost, and Electronic
Thermal Protection. Expanded descriptions of these parameters may be found in the section titled
Direct Access Information on pg.
Accel/Decel Group — One of four Accel/Decel profiles may be selected and run. Each of the
Accel/Decel profiles is comprised of three user settings: Acceleration, Deceleration, and Pattern.
Expanded descriptions of these parameters may be found in the section titled
Information on pg.
Feedback in Panel Mode — Enables or disables the PID feedback function.
Torque Limit Group — Used to select one of four preset positive torque limits to apply to the
active motor (of a multiple motor configuration). The settings of profiles 1 – 4 may be setup at F441,
F444, F446, and F448, respectively.
ACE-tronics G9 ASD Installation and Operation Manual
Buy: www.ValinOnline.com | Phone 844-385-3099 | Email: CustomerService@valin.com
F304 or the DC Injection Braking system setup at F250, F251, and F252.
79.
79.
Direct Access
53