Toshiba ACE-tronics G9 ASD Installation And Operation Manual page 168

F424
Load Sharing Gain Input
Program  Torque  Torque Control
This parameter Enables/Disables the Load Sharing Gain input function.
This feature is enabled by selecting a Load Sharing Gain input signal source.
Settings:
Disabled
V/I
RR
RX
Panel Keypad
RS485 2-Wire
RS485 4-Wire
Communication Option Board
RX2 Option (AI1)
Forward Speed Limit Input
Program  Torque  Torque Speed Limiting
This parameter Enables/Disables the Forward Speed Limit Input control
function. When enabled and operating in the Torque Control mode, the
forward speed limit is controlled by the input selected here.
If Setting is selected, the value set at
input.
Settings:
Disabled
V/I
RR
RX
F426 Setting
Forward Speed Limit Level
Program  Torque  Torque Control
This parameter provides a value to be used as the Forward Speed Limit setting
if F426 Setting is selected at F425.
158
Buy: www.ValinOnline.com | Phone 844-385-3099 | Email: CustomerService@valin.com
F426 is used as the Forward Speed Limit
Direct Access Number — F424
Parameter Type — Selection List
Factory Default — Disabled
Changeable During Run — Yes
Direct Access Number — F425
Parameter Type — Selection List
Factory Default — Disabled
Changeable During Run — Yes
Direct Access Number — F426
Parameter Type — Numerical
Factory Default — 60.00
Changeable During Run — Yes
Minimum — 0.00
Maximum — Upper Limit (F012)
Units — Hz
ACE-tronics G9 ASD Installation and Operation Manual
F426