F727
Panel Tension Torque Bias
Program Special Operation Panel Parameters
This function is not used with the ACE-tronics G9 ASD.
The Tension Torque Bias selection is performed at F423.
Panel Load Sharing Gain
Program Special Operation Panel Parameters
This function is not used with the ACE-tronics G9 ASD.
The Load Sharing Gain selection is performed at F424.
Panel Override Multiplication Gain
Program Special Operation Panel Parameters
This parameter provides a value to be used in the event that Setting (F729) is
selected for the Frequency Override Multiplying Input (F661).
Panel Frequency Lockout
Program Special Operation Panel Parameters
This function is not used with the ACE-tronics G9 ASD.
Settings:
Unlocked
Locked
Panel Emergency Off Lockout
Program Special Operation Panel Parameters
This function is not used with the ACE-tronics G9 ASD.
Settings:
Unlocked
Locked
Panel Reset Lockout
Program Special Operation Panel Parameters
This function is not used with the ACE-tronics G9 ASD.
Settings:
Unlocked
Locked
194
Buy: www.ValinOnline.com | Phone 844-385-3099 | Email: CustomerService@valin.com
Direct Access Number — F727
Parameter Type — Numerical
Factory Default — 0.00
Changeable During Run — Yes
Minimum — -250.00
Maximum — +250.00
Units — %
Direct Access Number — F728
Parameter Type — Numerical
Factory Default — 100.00
Changeable During Run — Yes
Minimum — 0.00
Maximum — 250.00
Units — %
Direct Access Number — F729
Parameter Type — Numerical
Factory Default — 0.00
Changeable During Run — Yes
Minimum — -100.00
Maximum — 100.00
Units — %
Direct Access Number — F730
Parameter Type — Selection List
Factory Default — Unlocked
Changeable During Run — Yes
Direct Access Number — F734
Parameter Type — Selection List
Factory Default — Unlocked
Changeable During Run — No
Direct Access Number — F735
Parameter Type — Selection List
Factory Default — Unlocked
Changeable During Run — Yes
ACE-tronics G9 ASD Installation and Operation Manual
F735