Table of Contents
Advertisement
Electra Elite
System Hardware Manual
Table 5-30 System Board Components (Continued)
Item
D
Port Expansion Board (PEB) cable
E
Modem connector
F
Hard Drive (HD) LED
G
Universal Serial Bus (USB) connector
H
Local-Area Network (LAN) connector
I
Keyboard connector
J
Mouse connector
K
COM Serial Port connector
L
VGA Monitor connector
M
Switch SW3
DIP switch 1 default is Off so the voice messaging application starts
when the board is turned On. Set this switch On to start OS/2
software only.
DIP switch 2 default is Off for direct serial remote access
connections. Set this switch On for modem connections.
DIP switches 3 and 4 are not used and should be left On.
N
The Power button cuts the power to the board from the PC and the
hard drive and should not be used.
O
Voice messaging software LED
Green when software is active
Amber when active with possible application problem
Red when inactive or shut down
P
Shutdown switch
Default is On. Place Off to shut down the software and system board
properly before turning off the telephone system and disconnecting
the system board.
Place On before restarting – The board restarts only when the switch
is On.
Q
Shutdown LED
Red when switch is On
Green when switch is Off
After the LED goes off, turn off power to the KSU and disconnect the
board.
R
Make Busy switch and LED
Do not use. Must always be On red when installed.
Description
Issue 6
5 - 61
Advertisement
Table of Contents
