Adjusting Dtu/Dtp Multiline Terminal Height; Figure 6-20 Locating The Adjustment Tabs On The Dtu/Dtp Multiline Terminal; Figure 6-21 Raising The Base Plate On The Dtu/Dtp Multiline Terminal - NEC ElectraElite 48 System Hardware Manual

Issue 6
S 9
ECTION
A DTU/DTP
DJUSTING
M T
ULTILINE ERMINAL
H
EIGHT
6 - 18
The base plate on Electra Elite Multiline Terminals is hinged. The
bottom part can be adjusted to raise or lower the height of the
terminal.
1. Turn the Multiline Terminal upside down and locate the tabs
as shown in Figure 6-20 Locating the Adjustment Tabs on the
DTU/DTP Multiline
Figure 6-20 Locating the Adjustment Tabs on the DTU/DTP
Multiline Terminal
2. Push the adjustment tabs and raise the base plate until it
locks.

Figure 6-21 Raising the Base Plate on the DTU/DTP Multiline Terminal

Terminal.
Installing Electra Elite Multiline Terminals
Electra Elite