Table of Contents
Advertisement
Issue 6
8 - 30
5.
When an adapter is installed for the first time in a terminal, the base
cover on the Multiline Terminal must be modified. Two adapters can
be installed in the terminal, and two separate cutouts are provided.
Remove the applicable cutout/cutouts on the bottom of the base plate
with nippers. When only one adapter is being installed and it needs
an AC-R Unit for power, remove only the Right cutout as shown in
Figure 8-39 Modifying Base
6.
Turn the base plate with bottom down and release two tabs at the top
for each end cover (shown shaded) corresponding to applicable base
plate cutout/cutouts and remove the cover/covers.
7.
Remove the applicable dummy end/ends with nippers.
8.
When An AC-R Unit is required for power, remove the cutout on the
right side of the base plate (with the bottom facing up) to
accommodate the power adapter cord.
Installing Electra Elite IPK and D
Cover.
Figure 8-39 Modifying Base Cover
Electra Elite
term
Series i Equipment
Advertisement
Table of Contents
