Issue 6
7 - 4
6.
When an adapter is being installed, press tabs A and B to remove the
dummy end from the base plate as shown in
Base Plate Dummy
Figure 7-5 Removing Base Plate Dummy End
7.
Cut the dummy end in half as shown in
End in
Half.
8.
When an Adapter is installed in connector 1 as shown in
Installing Adapter in Connector
Figure 7-8 Installing Dummy End
End.
Figure 7-6 Cutting Dummy End in Half
1, install dummy end B as shown in
B.
Electra Elite
Figure 7-5 Removing
Figure 7-6 Cutting Dummy
Figure 7-7
Installing Optional Equipment