GE eBike III basic Series Service Manual page 84

d (
rIver InstallatIon vIrtual
Administrator rights are required to install the driver.
1. Start PC and Monitor.
2. Shut down all running programs (all programs
running in the background as well).
3. Insert the USB driver and manual CD (PN 2017911-
xxx) into the CD-ROM drive.
4. Depending on the Windows
start the appropriate driver from the CD:
Windows 2000 :
®
CP210x_VCP_Win2K_XP_S2K3 exe
Windows XP , Windows Vista
®
CP210x_VCP_XP_S2K3_Vista_7 exe
5. Follow the instructions given on the screen. Confirm
the installation if a warning for a non indentified
program is displayed.
6. Click „Finish" to start the first part of the USB driver
installation.
7. Connect the eBike with the USB cable to the PC and
place the eBike power switch in the ON position:
eBike is automatically recognized by WINDOWS and
the driver is loaded („Silicon Labs CP 210x").
8. Follow the instructions given on the screen.
9. Remove the CD from the drive unit.
C usB
HeCk InterfaCe
1. The eBike has to be connected to the PC via USB cable
and power switch in the ON position.
2. Start the WINDOWS „Device manager".
3. Double click "COM & LPT" to display all connections.
4. For CardioSoft/CS V6.71 and below:
If an USB Serial Port ("Silicon Labs CP 210x USB to
UART Bridge") is assigned from COM1 up to COM4, no
change is necessary. If an USB Serial Port higher than
COM4 is assigned, one of the COM ports 1 to 4 has to
be deactivated to use this port number with eBike.
5. For CardioSoft/CS V6.73 and above:
If an USB Serial Port ("Silicon Labs CP 210x USB to
UART Bridge") is assigned from COM1 up to COM32
no change is necessary. If an USB Serial Port higher
than COM32 is assigned, one of the COM ports 1 to 32
has to be assigned to use this port number with eBike.
- 84 -
CoM )
x
operating system used,
®
, Windows 7, Windows 8 :
® ®
eBike III basic / comfort 2018111-336 Rev. B