GE eBike III basic Series Service Manual page 91

2. Insert the jumper adapter into the corresponding
socket, to close all necessary connections.
3. Close the electronic housing and fix it to the
ergometer chassis again.
4. The COM module is connected with a short cable
plugged onto the 9 pole DSUB connector (PORT 1).
5. Use the plastic velcro tape to fix the COM module to
the housing of the eBike
Insert the appropriate digital and analog connecting
cables.
The analog adapter has to be activated in the eBike III
software as follows:
2018111-336 Rev. B
liu-pcb
com
module connector on port
com
module mounted on e
com
module connectorS
eBike III basic / comfort
with jumper adapter inStalled
1
interface
b iii
ike
- 91 -