Enabling Remote Service Agent/ Connection - GE CARESCAPE B850 Service Manual

CARESCAPE Monitor B850
4. In the Remote Service Configuration window, enter the applicable data:
HTTP Proxy Server Configuration
Item
Address
Port
Username and
Password
Remote Service Configuration
Item
System ID
Serial Number
Enterprise URL
Enterprise Tunnel
URL
Protocol
5. Select Save.
The changes will take effect immediately.

7.16.2 Enabling remote service agent/ connection

After the server has been configured for remote serviceability, the remote service agent must
be enabled for use.
1. Log in to Webmin.
2. Select Configuration > Remote Service.
3. In the Sub-Modules for Remote Service menu, select Control.
4. In the Remote Service Control window, enable or disable the Service Agent by selecting
Enable or Disable.
5. Select Save.
The changes will take effect immediately.
88
2106778-001
Description
- If this site uses an HTTP proxy server, a
specific site proxy server IP Address and
Port number are required for the
Remote Service communication to
work. Otherwise, select None.
- If the HTTP proxy server requires user
authorization, a specific Username, and
Password is required. Otherwise, select
None.
Description
Identifies the system to the GE back office
servers.
Identifies the unit and is set at the time of
manufacture.
If required, designate the address of the GE
backoffice servers required to
communicate with the Remote Service
Agent.
If required, designate the address of the GE
backoffice servers required to
communicate with the tunneling agent.
Identifies the protocol used to
communicate with the enterprise servers.
Comments
These values are
determined by the
customer.
Comments
These values are read-only
and are unique.
This address should never
be changed unless explicit
instructions are given to do
so.
This field is read-only and
cannot be changed.