Removing the Section Bypass Hose
1. Remove the retainer that secures the 90° barbed fitting
of the section bypass hose for the boom-section valves
from the bulkhead fitting at the back of the sprayer
tank
(Figure
28).
Figure 28
1. Retainer
2. 90° barbed fitting—section
bypass hose
(boom-section valves)
2. Remove the 90° barbed fitting from the bulkhead
fitting
(Figure
28).
Note: Retain the retainers for installation in
the Section Bypass Hose (page
the bypass hose for the boom-section valves.
8
Replacing the Valve Electrical
Connectors
Parts needed for this procedure:
6
Cable ties
5
3-pin adapter
1
4-pin adapter
Preparing the Wire Harness
1. At the back of the machine, remove the 3 tie wraps that
secure the convoluted tubing and inline-fuse block to
3. Bulkhead fitting (sprayer
tank)
Installing
37); you no longer need
the wire harness for the branch labeled
as shown in
VALVE
1. DIN connectors
2. Label
3. Convoluted tubing
2. Remove 76 mm (3 inches) section of convoluted tubing
as shown in
Figure
1. Removed section of convoluted tube—76 mm (3 inches)
3. Position the convoluted tubing toward the main branch
of the wire harness as shown in
16
RIGHT SPRAY
Figure
29.
Figure 29
4. Inline-fuse block
5. Cable ties
30.
Figure 30
Figure
31.