Installing The Agitation Valve Connector; Wiring Table — Agitation Valve - Toro Multi Pro 1750 Installation Instructions Manual

Installing the Agitation Valve Connector

1. Cut off the butt-splice connectors for the pink wire
and black wire of the 3-pin adapter
Figure 41
1. 3-pin adapter
2. Black wire
2. Strip 8 mm (5/16 inch) of insulation from the pink and
black wires of the 3-pin adapter
Note: You will connect the pink and black wires of
the 3-pin adapter in
Connector (page 22).
Figure 42
1. Black wire (3-pin adapter)
2. Pink wire (3-pin adapter)
3. Align the yellow and green wire of the DIN harness
with the white wire of the 3-pin adapter for the
agitation-valve (Figure
the agitation valve.
(Figure 41).
3. Pink wire
4. Butt-splice connector
(Figure 42).
Installing the Master-Spray Valve
3. Removed section of wire
insulation—8 mm (5/16
inch)
43); refer to the wire table for
1. 3-pin adapter
2. Butt-splice connector
(white wire—agitation
valve)
Wiring Table—Agitation Valve
Wire color codes—DIN wire
harness
Not applicable
Not applicable
Yellow/green
4. Insert the wire of the DIN wire harness into the
butt-splice connector of the 3-pin adapter.
5. Center the crimping tool over the butt-splice connector
and wires and crimp the connector securely.
6. Use a heat gun to shrink the insulating sleeve of the
butt-splice connector of the wires that you installed
in steps 3 through 5.
7. Terminate the brown and blue wire of the DIN
connector as follows:
A. Cut the conductors of the brown wire and blue
wire flush with the insulation
21
Figure 43
3. Yellow and green wire
(DIN harness—agitation
valve)
Wire color codes—3-pin
adapter (agitation-valve
position)
Pink
Black
White
(Figure 44).