Removing the Agitation-Manifold Valve
1. Remove the clamps and gaskets that secure the
manifold for the agitation valve to the agitation bypass
valve, pressure-filter head, reducer coupling, and
adapter fitting (agitation throttle valve) as shown in
Figure
112.
Note: Retain the clamps, gaskets, quick connect, and
quick-connect pin for installation in
Agitation-Manifold Valve (page
Figure 112
Agitation Valve
1. Flange (pressure-filter
head)
2. Manifold (agitation valve)
3. Flange (agitation bypass
valve)
4. Flange clamp
2. Remove the agitation-valve manifold from the machine
(Figure
113).
Installing the
57).
5. Gasket
6. Flange (adapter
fitting—agitation throttle
valve)
7. Flange (reducer coupling)
1. Agitation-valve manifold
Removing the Section Valve Manifold
1. Remove clamps and gaskets that secure the manifold
for the section valve
valve (if left, section valve and reducer coupling).
1. Flange (reducer coupling)
2. Manifold (section valve)
3. Flange (adjacent section
valve)
54
Figure 113
(Figure
114) to the adjacent section
Figure 114
4. Gasket
5. Flange clamp