Installing The Section Spray Valve Hoses; Installing The Upper Sprayer Supply Hose; Installing The Section Bypass Hose - Toro Multi Pro 1750 Installation Instructions Manual

Installing the Upper Sprayer Supply
Hose—Machines with the Optional
Eductor Kit
1. Align the straight barbed fitting of the upper supply
hose 25 x 22 cm (1 x 8-5/8 inches) and a gasket—25 x
35 mm (1 x 1-3/8 inches) with the flange of the adapter
on the eductor-shutoff valve
Figure 76
1. 90° flanged elbow—upper
supply hose 25 x 22 cm (1
x 8-5/8 inches)
2. Gasket—25 x 35 mm (1 x
1-3/8 inches)
3. Flange clamp—40 to
64 mm (1-9/16 to 2-1/2
inches)
2. Loosely assemble the hose to the adapter
with a flange clamp—40 to 64 mm (1-9/16 to 2-1/2
inches).
3. Align the 90° flanged elbow of the upper supply hose
and the gasket to the flange of the filter head
76).
4. Secure the 90° flanged elbow to the filter head
76) with a flange clamp—40 to 64 mm (1-9/16 to
2-1/2 inches).
5. Tighten the flange clamp that secures straight barbed
fitting of the upper supply hose to the adapter of the
eductor-shutoff valve
(Figure 76).
4. Filter head
5. Straight barbed fitting
6. Adapter (eductor-shutoff
valve)
(Figure
(Figure
(Figure
(Figure 76).
16
Installing the Section Spray
Valve Hoses
Parts needed for this procedure:
Section bypass hose—2.5 x 146 cm (1 x 57-1/2
1
inches)
Supply hose—left-boom section—2 x 205 cm (3/4 x
1
80-13/16 inches)
Supply hose—center-boom section—2 x 58 cm (3/4
1
x 22-13/16 inches)
Supply hose—right-boom section—2 x 170 cm (3/4
1
x 66-13/16 inches)

Installing the Section Bypass Hose

For machines without the optional spray gun kit
or the optional electric hose reel kit.
Note: If you are installing the valve conversion kit on
a machine with the optional hand spray wand kit or the
optional electric hose reel kit, skip this procure. You will
install the section bypass hose in
Hose—Machines with the Optional Spray Gun Kit or the
Optional Electric Hose Reel Kit (page
1. Assemble the 90° quick-connect fitting of the section
bypass hose—2.5 x 146 cm (1 x 57-1/2 inches) onto
the quick coupling of the bypass manifold with the
retainer (small) that is supplied with the section bypass
hose (Figure
76)
37
Installing the Section Bypass
46).
77).