Installing The Valve Manifolds; Installing The Agitation, Rate, And Master-Spray Valve Manifold; Installing The Section Valve Manifold - Toro Multi Pro 1750 Installation Instructions Manual

9

Installing the Valve Manifolds

Parts needed for this procedure:
1 Agitation, rate, and master-spray manifold
1 Section valve manifold
Installing the Agitation, Rate, and
Master-Spray Valve Manifold
1. Align the 3 holes in the bracket of the agitation, rate,
and master-spray valve with the mount
Figure 48
1. Bracket
2. Mount
2. Assemble the bracket for the agitation, rate, and
master-spray valves to the mount
the 3 flange-head bolts (5/16 x 3/4 inch) that you
removed in step 1 of
and Master-Spray Valves from the Machine (page
3. Torque the flange-head bolts to 1878 to 2542 N∙m (175
to 225 in-lb).
(Figure 48).
3. Flange-head bolts (5/16 x
3/4 inch)
(Figure 48) with
Removing the Agitation, Rate,

Installing the Section Valve Manifold

1. Align the 4 holes in the bracket for the section-valve
with the 4 holes in the mount
1. Mount
2. Bracket
2. Assemble the bracket for the section valve to the
bracket mount
bolts (5/16 x 3/4 inch) that you removed in step
Removing the Boom-Section Valves, Supply Hoses,
and Section-Valve Mount (page
3. Torque the flange-head bolts to 1878 to 2542 N∙m (175
to 225 in-lb).
4. Secure the wire harness of the machine to the bracket
for the agitation, rate, and master-spray valves and
the bracket for the section valves with the 5 push-in
fasteners (Figure
15).
24
(Figure 49).
Figure 49
3. Flange-head bolt (5/16 x
3/4 inch)
(Figure 49) with the 4 flange-head
13).
50).
1 of