8. Assemble the and 2 adjacent section valve manifolds
and gasket with a clamp, and tighten by hand
144).
9. If you loosened the mounting hardware for the bypass
valve, tighten the nut and bolt to 1017 to 1243 N∙cm
(90 to 110 in-lb).
Installing the Valve Actuator
1. Align the actuator to the manifold valve.
2. Secure the actuator and valve with the retainer that you
removed in step
3
of
(page
56).
(Figure
Removing the Valve Actuator
Storage
Perform the following maintenance steps for short-term or
long-term storage:
•
For short-term storage (less than 30 days), clean the
sprayer system; refer to your Operator's Manual.
•
For long-term storage (longer then 30 days), clean the
agitation valve and the 3 section valves; refer to
the Agitation and Section Valves (page
62
Cleaning
56).