Assembling The Manifold Valve - Toro Multi Pro 5800-D Installation Instructions Manual

Figure 141
Section Valve Manifold
1. Valve-stem seat
2. Valve-stem assembly
3. Stem port
4. Stem retainer
5. Outlet fitting O-ring (0.737
inch / 0.103 inch)
6. End-cap fitting
3. Turn the valve stem so that the ball is in the O
position (Figure 139).
Note: The valve stem should be parallel with the valve
flow and the ball should slide out.
4. Remove the stem retainer from the slots in the stem
port in the manifold
5. Remove the stem retainer and valve-stem seat from the
manifold (Figure 140
6. Reach into the manifold body and remove the
valve-stem assembly
7. Clean the inside of the manifold and exterior of the
ball valve, valve-stem assembly, stem capture, and end
fittings.
7. End cap O-ring (0.796 inch
/ 0.139 inch)
8. Back seating O-ring (0.676
inch / 0.07 inch)
9. Ball seat
10. Manifold body
11. Ball valve
12. End-cap-fitting assembly
(Figure 140 and Figure 141).
and Figure 141).
(Figure 140 and Figure 141).

Assembling the Manifold Valve

1. Check the condition of the outlet fitting O-rings
(section valve manifold only), end cap O-rings, back
seating O-rings, and ball seat for damage or wear
(Figure 140
Note: Replace any damaged or worn O-rings or seats.
2. Apply grease to the valve stem and insert it into the
valve-stem seat
3. Install the valve stem and seat into the manifold and
secure the stem and seat with the stem retainer
140 and
4. Ensure that the back seating O-ring and the ball seat
are aligned and seated into the end-cap fitting
140 and
5. Install the end-cap-fitting assembly onto the manifold
body until the flange of the end-cap fitting touches the
manifold body
the end-cap fitting an additional 1/8 to 1/4 turn.
Note: Use caution to prevent damage to the end of
the fitting.
6. Insert the ball into the valve body
Note: The valve stem should fit inside the ball-drive
slot. If the valve stem does not fit, adjust the position
of the ball
PEN
7. Turn the valve-stem assembly so that the valve is closed
(Figure
8. Repeat steps
assembly.
60
and Figure 141).
(Figure 140 and Figure
Figure 141).
Figure 141).
(Figure 140 and Figure
(Figure 142).
Figure 142
139).
4 and 5 for the other end-cap-fitting
141).
(Figure
(Figure
141), then turn
(Figure 142).