Toro Multi Pro 5800-D Installation Instructions Manual page 48

Connecting the Wire Harness to the
Boom-Section Valves and the Agitation
Valve
1. Connect the 3-pin connector for the actuator of
the agitation valve into the 3-socket connector
labeled A
GITATION
wire-harness branch
Figure 114
1. Left actuator
(boom-section valve)
2. Center actuator
(boom-section valve)
3. Right actuator
(boom-section valve)
4. 3-pin connector
(harnesses—section-valve
actuators)
5. Actuator (agitation-valve)
2. Connect the 3-pin connector for the actuator of the
left-boom-section valve into the 3-socket connector
labeled L -S
EFT PRAY
3. Connect the 3-pin connector for the actuator of the
center-boom-section valve into the 3-socket connector
labeled C -S
ENTER PRAY
4. Connect the 3-pin connector for the actuator of the
right-boom-section valve into the 3-socket connector
labeled R -S
IGHT PRAY
V of the 76 cm (30 inches)
ALVE
(Figure 114).
6. 3-socket connector
(agitation valve)
7. 3-socket connector
(labeled R -S
IGHT PRAY
V )
ALVE
8. 3-socket connector
(labeled L -S
EFT PRAY
V )
ALVE
9. 3-socket connector
(labeled A
GITATION
V .
ALVE
V .
ALVE
V .
ALVE
Connecting the Wire Harness to the
Solenoids for the Lift-Cylinder Manifold
1. At the lower left solenoid, connect the 2-socket
connector of the rear wire harness labeled L
S
OLENOID
solenoid
1. 2-pin connector—right
down solenoid (lift-cylinder
manifold)
V )
ALVE
2. 2-pin connector—right
up solenoid (lift-cylinder
manifold)
3. 2-pin connector—left
up solenoid (lift-cylinder
manifold)
4. 2-pin connector—left
down solenoid (lift-cylinder
manifold)
5. Front of the machine
6. 2-socket
connector—R
S
OLENOID
connector)
2. At the upper left solenoid, connect the 2-socket
connector of the rear wire harness labeled L
S
OLENOID
solenoid
48
into the 2-pin connector for the left down
(Figure 115).
Figure 115
7. 2-socket
connector—R
S
OLENOID
connector)
8. 2-socket connector—L
U S
P
(main-harness connector)
9. 2-socket connector—L
D
OWN
(main-harness connector)
10. 2–pin connector—enable
solenoid (lift-cylinder
manifold)
11. 2-socket
connector—E
S
OLENOID
connector)
IGHT DOWN
(main-harness
into the 2-pin connector for the left up
(Figure 115).
D
EFT OWN
U
IGHT P
(main-harness
EFT
OLENOID
EFT
S
OLENOID
NABLE
(main-harness
U
EFT P