Toro Multi Pro 5800-D Installation Instructions Manual page 25

10
Installing the Agitation Shutoff
Valve, Nozzles, and Hoses
Parts needed for this procedure:
1 Screw (6-32 x 5/8 inch)
1 Handle
1 Agitation throttle valve
1 Bracket (nylon)
1 Agitation-valve bracket
1 Bolt (6 x 12 mm)
1 Agitation supply hose
1 Agitation-nozzle assembly
1 Agitation bypass hose—25 x 254 mm (1 x 10 inches)
1 Gasket—25 x 35 mm (1 x 1-3/8 inches)
1 Flange clamp—40 to 64 mm (1-9/16 to 2-1/2 inches)
Assembling the Agitation Throttle Valve
1. Assemble the handle to the agitation throttle valve
(Figure 52) with the screw (6-32 x 5/8 inch).
1. Screw (6-32 x 5/8 inch)
2. Handle
3. Agitation throttle valve
4. Throttle valve mount
(nylon)
2. If not assembled, insert the 4 stainless steel nuts into
the slots in the nylon throttle valve mount for the
agitation throttle valve
3. Assemble the agitation throttle valve into the throttle
valve mount as shown in
4. Secure the throttle valve mount to the agitation throttle
valve with the screw (6-32 x 5/8 inch) as shown in
(Figure 52).
5. Assemble the throttle valve and mount to the
agitation-valve bracket
12 mm).
6. Align the holes in the agitation-valve bracket with the
holes in the sprayer-pump bracket
25
Figure 52
5. Nut-stainless steel (6
mm—throttle valve mount)
6. Washer-head screw
(#6—throttle valve mount)
7. Agitation-valve bracket
8. Bolt (6 x 12 mm)
(Figure 52).
(Figure 52)
(Figure 52) with the 4 bolt (6 x
(Figure 53).