Toro Multi Pro 5800-D Installation Instructions Manual page 22

Assembling the Flow Meter
Machines with the Optional Pro-Control Kit
1. Remove the 2 flange clamps that secure the 2 gaskets
and straight coupling to the adapter couplings at the
agitation valve and the left-boom-section valve
47).
Note: If needed, loosen the 4 flange-head bolts (1/4 x
3/4 inch) and the flange locknuts (1/4 inch) that secure
the 3 boom-section valves to the valve bracket. You no
longer need the adapter coupling.
Figure 47
1. Adapter coupling (at the
agitation valve)
2. Adapter coupling (at the
left-boom-section valve)
3. Straight coupling
2. Align the gaskets that you removed in step
flow meter that you removed in
Meter (page 18).
3. Align the gaskets and flow meter with the flanges of
the adapter couplings at the agitation valve and the
left-boom-section valve
4. Secure the flow meter to the adapter couplings with the
2 flange clamps that you removed in step
5. If you loosened the 4 flange-head bolts (1/4 x 3/4
inch) and the flange locknuts (1/4 inch) that secure the
3 boom-section valves to the valve bracket, torque the
nuts and bolts to 102 to 124 N∙m (90 to 110 in-lb).
(Figure
4. Gasket
5. Flange clamp
6. Flow meter
1 with the
Removing the Flow
(Figure 47).
1 (Figure
Assembling the Valve Assembly to the
Valve Mount
1. Align the holes in the valve bracket with the
sprayer-valve assembly to the holes in the valve mount
(Figure 48 and
1. Flange-head bolts (5/16 x
1 inch)
2. Valve bracket
(sprayer-valve assembly)
2. Assemble the valve bracket to the valve mount
48 and Figure
1 inch) and 5 flange locknuts (5/16 inch).
47).
22
Figure 49).
Figure 48
3. Valve mount
4. Flange locknuts (5/16
inch)
49) with the 5 flange-head bolts (5/16 x
(Figure