Toro Multi Pro 5800-D Installation Instructions Manual page 37

Figure 81
1. Flange locknut (5/16 inch)
2. Flange-head bolt (5/16 x
1 inch)
2. Ensure that the 2 rubber washers are assembled to the
2 mount pegs of the drain valve
Figure 82
1. Sprayer-pump bracket
2. Rubber washer
3. Cable (lynch pin)
4. Hole 8 mm (5/16
inch)—sprayer-pump
bracket
(Figure 82).
3. Mount peg
4. Lynch pin
3. Align the 2 mount pegs through the 2 holes 11 mm
(7/16 inch) in the sprayer-pump bracket
4. Secure the drain valve to the pump bracket with the
lynch pin (Figure
14
Installing the Boom-Section
Hoses
Parts needed for this procedure:
Supply hose—left boom section—2 x 205 cm (3/4 x
1
80-13/16 inches)
Supply hose—center boom section— 2 x 58 cm (3/4
1
x 22-13/16 inches)
Supply hose—right boom section—2 x 170 cm (3/4
1
x 66-13/16 inches)
Routing and Connection the Supply
Hoses at the Boom-Section Valves
1. Route the left, center, and right boom-supply hoses to
the boom-section valves as shown in
1. Left boom-supply hose
2. Center boom-supply hose
2. Assemble the straight barbed fitting of the supply hose
for the left boom-supply hose onto the quick-connect
fitting at the left-boom-section valve
37
(Figure
82).
Figure
Figure 83
3. Right boom-supply hose
(Figure
82).
7.
84).