Toro Multi Pro 5800-D Installation Instructions Manual page 7

2
Disconnecting the Rear Wire
Harness from the Optional
Attachments
No Parts Required
Disconnecting the Wire Harness from
the Optional Spray Gun Kit or Electric
Hose-Reel Kit
1. At the back of the sprayer tank, locate the wire harness
for the spray gun kit or electric hose-reel kit
1. Control box (spray gun kit
or electric hose-reel kit)
2. 6-pin connector
(harness—spray gun
kit or electric hose-reel kit)
2. Disconnect the 6-pin connector of the harness for the
spray gun kit or electric hose reel-kit from the 6-socket
of the rear wire harness
(Figure
Figure 5
3. 6-socket (rear wire
harness)
(Figure 5).
Disconnecting the Compressor for the
Foam-Marker Kit
1. At the back of the foam-marker tank, locate the wire
harness at the compressor
5).
1. Compressor
2. 4-pin connector (wire
harness for the
compressor)
2. Disconnect the 4-pin connector of the compressor
harness from the from the 4-socket connector of the
rear wire harness of the machine
Disconnecting the Pump for the
Tank-Rinse Kit
1. At the back of the machine, press together the sides of
the rinse-pump cover and lift the cover up until the
tabs of the cover clear the slots in the saddle plate, and
remove the cover from the machine
7
(Figure 6).
Figure 6
3. 4-socket connector (wire
harness for the finishing
kit)
(Figure 6).
(Figure 7).
Figure 7