Toro Multi Pro 5800-D Installation Instructions Manual page 20

7
Removing the Valve Support
and Boom-Section Valves
No Parts Required
Removing the Boom-Section Hoses
1. At the outer-boom section, remove the hose clamp
that secures the supply hose for the boom section to
the barbed T-fitting
Figure 42
1. Barbed T-fitting
2. Supply hose (outer-boom
section)
3. Outer-boom section
2. Remove the hose from the T-fitting
3. Remove the free end of the hose from the R-clamp
(Figure 42).
4. Repeat steps 1 through
other outer-boom section.
5. Under the center-boom section, remove the hose
clamp that secures the supply hose for the boom
section to the barbed T-fitting
Note: Retain the hose clamps from the outer and
center boom sections for installation in
the Boom-Section Hoses (page
the left, center, and right boom-section hoses.
(Figure 42).
4. Hose clamp
5. R-clamp
(Figure 42).
3 for the supply hose at the
(Figure 43).
14 Installing
37); you no longer need
1. Center-boom-section
valve
2. Center-boom section
3. Left side of the machine
Removing the Valve Support
Valve support, valves, and boom-section hoses weight:
approximately 20.4 kg (45 lb).
Have another person help you remove the valve support.
1. Remove the 2 Phillips-head screws (#10 x 5/8 inch)
and 2 washers (#10) that secure the lower T-fitting to
the valve support
1. Valve support
2. T-fitting (upper)
3. Washer (#10)
20
Figure 43
4. Hose (center-boom
section)
5. Hose clamp
6. Barbed T-fitting
(Figure 44).
Figure 44
4. Phillips-head screw ( #10
x 5/8 inch)
5. T-fitting (lower)