Preparing The Machine - Toro Multi Pro 5800-D Installation Instructions Manual

1
Preparing to Install the Kit
No Parts Required

Preparing the Machine

1. Move the machine to a level surface
2. Set the parking brake
3. Shut off the engine and remove the key
Preparing the Sprayer and Optional
Rinse Tank
1. Clean the sprayer; refer to Cleaning the Sprayer in the
Operator's Manual for the machine.
Important: You must completely empty the
sprayer tank before installing the valve conversion
kit.
2. For machines with the optional tank-rinse kit,
perform the following: Pump the water from the
rinse tank into the sprayer tank; refer to Operating
the Rinse Kit in the Installation Instructions for the
Tank-Rinse Kit.
3. Drain the water from the sprayer tank
to Cleaning the Sprayer in the Operator's Manual for the
machine.
(Figure 1).
Figure 1
(Figure 1).
(Figure
(Figure
1).
1. Lynch pin
2. Mount peg
3. Drain valve
4. Flange locknut (5/16 inch)
4. Remove the flange-head bolt (5/16 x 1 inch) and flange
locknut (5/16 inch) that secure the cable of the lynch
pin to the hydraulic-tank support
Note: Retain the lynch pin, flange locknut, flange-head
bolt, and 2 rubber washers for installation
the Drain Valve (page
2); refer
5
Figure 2
5. Cable (lynch pin)
6. Flange-head bolt (5/16 x
1 inch)
7. Support (hydraulic tank)
8. Rubber washer
(Figure 2).
Installing
36).