Toro Multi Pro 5800-D Installation Instructions Manual page 46

4. Connect the 8-pin connector of the front wire harness
for the sprayer-harness interconnect into the 8-socket
connector of the rear wire harness for the rate switch
(Figure 108).
Figure 108
1. Front wire harness
2. 8-pin
connector—sprayer-harness
interconnect (front wire
harness)
3. 8-socket connector—rate
switch (rear wire harness)
5. Connect the 2-pin connector of the front wire harness
for the rinse pump into the 2-socket connector of the
rear wire harness for the rinse pump
Figure 109
1. Front wire harness
2. 2-socket connector—rinse
pump (rear wire harness)
3. 2-pin connector—rinse
pump (front wire harness)
6. Connect the 10-pin connector of the front wire
harness for the sprayer-harness interconnect into the
10-socket connector of the rear wire harness for the
sprayer-harness interconnect
4. Rear wire harness
5. Front of the machine
(Figure 109).
4. Rear wire harness
5. Front of the machine
(Figure 110).
1. Front wire harness
2. 10-pin
connector—sprayer-harness
interconnect (front wire
harness)
3. 10-socket
connector—sprayer-harness
interconnect (rear wire
harness)
Routing the Pressure-Sense Tube for
the Dash Gauge along the Rear Wire
Harness
1. Route the pressure-sense tube for the dash gauge along
the rear wire harness of the machine
1. Cable ties (3 push-in
fastener—chassis anchor
points)
2. Front of the machine
2. Secure the pressure-sense tube to the rear wire harness
with 3 cable ties adjacent to the 3 push-in fasteners
at the chassis anchor points for the rear wire harness
(Figure 111).
Important: Do not pinch or collapse the
pressure-sense tube; tighten the cable ties only
enough to support the tube.
46
Figure 110
4. Rear wire harness
5. Front of the machine
(Figure
Figure 111
3. Pressure-sense tube
4. Rear wire harness
111).