No Parts Required - Toro Multi Pro 5800-D Installation Instructions Manual

2. Disconnect the 6-pin connector of the rinse-pump
harness from the 6-socket connector of the rear wire
harness (Figure 8).
1. Rinse pump
2. 6-socket connector (rear
wire harness)
Disconnecting the Wire Harness from
the Optional Pro-Control Kit
Disconnect the 3-pin connector of the flow-meter harness
from the 3 socket connector of the rear wire harness of the
machine (Figure 9).
1. 3-pin connector
(flow-meter harness)
2. 3 socket connector (rear
wire harness—machine)
Figure 8
3. 6-pin connector
(rinse-pump harness)
Figure 9
3. Flow meter
3
Disconnecting the
Pressure-Sense Tube for
the Dash Gauge

No Parts Required

Disconnecting the Pressure-Sense
Tube for the Dash Gauge—Machines
Without an Optional Hose-Reel Kit
Note: If your machine is equipped with an optional spray
gun kit, refer to Disconnecting Pressure-Sense Tube and
Supply Hose—Optional Spray-Gun Kit or Electric Hose-Reel
Kit (page 9).
1. Press in the collar for the tube coupler in the ported-cap
fitting of the right-boom-section valve
1. Tube coupler (end cap
of the right-boom-section
valve)
2. Ported-cap fitting
2. Pull the pressure-sense tube for the dash gauge out of
the tube coupler
8
(Figure
Figure 10
3. Pressure-sense tube
(Figure 10).
10).