Toro Multi Pro 5800-D Installation Instructions Manual page 10

4
Removing the Rear Wire
Harness for the Machine
Parts needed for this procedure:
1 Rear wire harness
Disconnecting the Front and Rear Wire
Harnesses
Note: Use a machine hoist when disconnecting the front
and rear wire harnesses.
1. Front of the machine
1. From under the machine along the right frame tube,
locate the electrical connectors for the front and rear
wire harnesses of the machine
2. Disconnect the 6 pairs of connectors between the front
and rear wire harnesses as shown in
Figure 19.
Figure 14
(Figure 14).
Figure 15 through
10
2. Connector interfaces (front and rear wire harnesses)