Toro Multi Pro 5800-D Installation Instructions Manual page 49

3. At the upper right solenoid, connect the 2-socket
connector of the rear wire harness labeled R
S into the 2-pin connector for the right up
OLENOID
solenoid (Figure 115).
4. At the lower right solenoid, connect the 2-socket
connector of the rear wire harness labeled R
S
DOWN OLENOID
right down solenoid
5. At the bottom of the lift-cylinder manifold, connect
the 2-socket connector of the rear wire harness labeled
E S
NABLE OLENOID
enable solenoid (Figure
Connecting the Wire Harness to the
Sprayer Pump and the Speed Sensor
1. At the back of the machine—inboard of the sprayer
pump, connect the 2-socket connector of the 86 cm
(34 inch) wire-harness branch into the 2-pin connector
of the relay for the pump
Figure 116
1. 2-pin connector (pump
relay)
2. 2-socket connector—86
cm (34 inch) wire-harness
branch
2. At the back of the machine (between the right
frame tube and the right fender) connect the 3-pin
connector of the speed-sensor harness at the right
hydraulic-traction motor into the 3-socket connector
(unmarked) of the rear wire harness
into the 2-pin connector for the
(Figure 115).
into the 2-pin connector for the
115).
(Figure 116).
3. Front of the machine
(Figure
U
IGHT P
IGHT
1. 3-socket connector (rear
wire harness)
2. 3-pin connector
(hydraulic-motor harness
18
Connecting the Rear Wire
Harness to the Optional
Attachments
Parts needed for this procedure:
Jumper harness (optional spray gun kit or electric
1
hose-reel kit)
Connecting the Wire Harness to the
Optional Spray Gun Kit or Optional
Electric Hose-Reel Kit
1. At the back of the machine, remove the cap from the
4-socket connector of the rear wire harness labeled
H
OSE
117).
49
Figure 117
3. Front of the machine
R (Figure 118)
EEL