No Parts Required - Toro Multi Pro 5800-D Installation Instructions Manual

17
Connecting the Rear Wire
Harness

No Parts Required

Routing the Wire Harness at the
Manifold Mount
1. Route the 76 cm (30 inches) branch of the wire harness
inboard of the support strut for the valve mount and
rearward toward the boom-section valves and agitation
valve as shown in Figure
Figure 112
1. Manifold mount
2. 3–socket connector
(boom-section valves and
agitation valve)
3. 3-socket connector (flow
meter)
4. Push-in fastener
2. Insert the push-in fasteners of the 76 cm (30 inches)
branch into the holes in the lower flange of the
manifold mount (Figure
112.
5. 2-socket connector (rinse
pump)
6. 76 cm (30 inches)
wire-harness branch—left,
center, and right spray
valves, agitation valve,
and flow meter
7. 2-pin connector (2015 and
newer hose-reel power)
8. 3-socket connector (hose
reel)
112).
Routing the Wire Harness for the
Sprayer Pump
1. Route the 74 cm (29 inches) wire-harness branch for
the spray-pump solenoid across the top of the sprayer
frame channel and down toward the sprayer-pump
solenoid (Figure
1. 74 cm (29 inches)
wire-harness
branch—spray-pump
solenoid
2. 76 cm (30 inches)
wire-harness branch—left,
center, and right spray
valves, agitation valve,
and flow meter
3. Channel (sprayer frame)
2. Insert the push-in fastener of the 74 cm (29 inches)
wire-harness branch into the hole in the sprayer frame
channel (Figure
47
113).
Figure 113
4. Front of the machine
5. Push-in fastener
113).