Toro Multi Pro 5800-D Installation Instructions Manual page 45

Figure 103
1. Rear wire harness—168
cm (66 inches) branch
2. Right frame tube
4. Insert the 3 push-in fasteners of the 168 cm (66 inches)
branch of the rear wire harness into the holes in
the right frame tube
fasteners of the old rear wire harness were removed;
refer to step 3 in Disconnecting the Front and Rear
Wire Harnesses (page
Connecting the Front and Rear Wire
Harnesses
Note: Use a machine hoist when connecting the front and
rear wire harnesses.
1. From under the machine along the right frame tube,
locate the electrical connectors for the front and rear
wire harnesses of the machine
Figure 104
1. Front of the machine
Note: You will not use the 3-socket connector of the
front wire harness (Figure
3. Front of the machine
4. Push-in fasteners and
cable tie locations
(Figure 103) where the push-in
10).
(Figure 104).
2. Connector interfaces (front
and rear wire harnesses)
105).
1. Front wire harness
2. 2-socket connector—not
used (2015 and newer
hose-reel power)
2. Connect the 10-socket connector of the front wire
harness for the sprayer-harness interconnect into the
10-pin connector of the rear wire harness for the
sprayer-harness interconnect
1. Front wire harness
2. 10-socket
connector—sprayer-harness
interconnect (front wire
harness)
3. 10-pin
connector—sprayer-harness
interconnect (rear wire
harness)
3. Connect the 3-socket connector of the front wire
harness for the flow meter into the 3-pin connector of
the rear wire harness for the flow meter
1. Front wire harness
2. 3-socket connector—flow
meter(front wire harness)
3. 3-pin connector—flow
meter (rear wire harness)
45
Figure 105
3. Rear wire harness
4. Front of the machine
(Figure 106).
Figure 106
4. Rear wire harness
5. Front of the machine
(Figure
Figure 107
4. Rear wire harness
5. Front of the machine
107).