Removing The Flow Meter From The Valve Manifolds; Removing The Bypass Hose From The Boom-Section Valves - Toro Multi Pro 1750 Installation Instructions Manual

Removing the Flow Meter from the
Valve Manifolds
1. Remove the flange clamp that secures the barbed
flange fitting of the flow meter hose to the flow meter
(Figure 16).
Figure 16
1. Flange clamp
2. Gasket
3. Flow meter
2. Remove the flange clamp that secure the flow meter
to the adapter fitting at the left boom-section valve
(Figure 16).
3. Remove the flow meter and 2 gaskets from the valve
manifolds (Figure 16).
Note: Set the flow meter aside—do not remove the
electrical connector; retain the flange clamps and
gaskets for installation in
(page 26).
4. Barbed flange fitting
(flow-meter hose)
5. Adapter fitting (left
boom-section valve)
Installing the Flow Meter
Removing the Bypass Hose from the
Boom-Section Valves
1. Remove the retainer that secures the 90° barbed fitting
of the bypass hose from the socket fitting of the bypass
valve at the right boom section valve
1. Bypass manifold
(boom-section valves)
2. Retainer
2. Remove the bypass hose from the bypass valve
17).
12
(Figure
Figure 17
3. Bypass hose
17).
(Figure