Assemble Eductor–Shutoff Valve For Machines W. Optional Eductor Kit; Assemble The Throttle Valve For Machines W/O Optional Eductor Kit - Toro Multi Pro 1750 Installation Instructions Manual

Figure 58
1. Screw (6-32 x 5/8 inch)
2. Handle
3. Agitation throttle valve
4. Throttle-valve mount
(nylon)
2. If not assembled, insert the 4 stainless steel nuts into
the slots in the nylon throttle-valve mount for the
agitation throttle valve
3. Assemble the agitation throttle valve into the
throttle-valve mount as shown in
4. Secure the throttle-valve mount to the agitation throttle
valve with the screw (6-32 x 5/8 inch) as shown in
(Figure 58).
5. Assemble the throttle valve and mount to the
agitation-valve bracket
12 mm).
5. Nut—stainless steel (6
mm—throttle-valve mount)
6. Washer-head screw
(#6—throttle-valve mount)
7. Agitation-valve bracket
8. Bolt (6 x 12 mm)
(Figure 58).
(Figure 58)
(Figure 58) with the 4 bolt (6 x
Assembling the Eductor–Shutoff Valve
for Machines with the Optional Eductor
Kit
1. Align the hose in the eductor-shutoff bracket with the
studs of the eductor-shutoff valve as shown in
59.
1. Flange locknut (1/4 inch)
2. Eductor-shutoff bracket
2. Assemble the bracket to the valve
4 flange locknuts (1/4 inch)
3. Torque the flange locknuts to 1017 to 1243 N∙cm (90
to 110 in-lb).
Assembling the Throttle Valve for
Machines without the Optional Eductor
Kit
Note: If your machine has the optional eductor kit, skip to
Assembling the Throttle Valve and Eductor-Shutoff Valve for
Machines with the Optional Eductor Kit (page
1. Align the slots in the agitation-valve bracket with
the holes in the mount for the throttle-valve bracket
(Figure 60).
1. Mount (throttle-valve
bracket)
2. Agitation-valve bracket
29
Figure 59
3. Stud (eductor-shutoff
valve)
(Figure 59) with the
30).
Figure 60
3. Flange-head bolt (5/16 x
3/4 inch)
4. Front of the machine
Figure