Installing The Supply Hose For The Optional Eductor Kit - Toro Multi Pro 1750 Installation Instructions Manual

18
Installing the Supply Hose for
the Optional Eductor Kit
Parts needed for this procedure:
1 Eductor supply hose 2 x 88 cm (3/4 x 34-11/16 inches)
1
Retainer (small)
Procedure
1. Align the straight barbed fitting of the eductor supply
hose 2 x 88 cm (3/4 x 34-11/16 inches) with the
gasket that you removed in step
the Optional Eductor Kit (page 9)
the eductor (Figure
2 of Disconnecting
with the flange of
101).
1. Flange (eductor)
2. Gasket
3. Flange clamp
4. Straight barbed fitting
2. Loosely assemble the barbed fitting to the eductor
flange with the flange clamp that you removed in step
1 of Disconnecting the Optional Eductor Kit (page 9)
3. Route the eductor supply hose to the bottom of the
eductor-shutoff valve as shown in
47
Figure 101
5. Eductor supply hose 2
x 88 cm (3/4 x 34-11/16
inches)
6. Bottom port
(eductor-shutoff valve)
7. 90° barbed fitting
8. Retainer (small)
Figure 102.