Toro Multi Pro 1750 Installation Instructions Manual page 56

Figure 118
Agitation Valve Manifold
1. Stem retainer
2. Valve stem
3. Stem port
4. Stem retainer
5. End-cap fitting
6. End-cap-seal O-ring
(0.796 inch / 0.139 inch)
7. Back seating O-ring (0.676
inch / 0.07 inch)
8. Valve-seat ring
9. Manifold body
10. Ball valve
11. Quick connect
Section Valve Manifold
1. Valve-stem seat
2. Valve-stem assembly
3. Stem port
4. Stem retainer
5. Outlet fitting O-ring (0.737
inch / 0.103 inch)
6. End-cap fitting
3. Turn the valve stem so that the ball is in the O
position (Figure
Note: The valve stem should be parallel with the valve
flow and the ball should slide out.
4. Remove the stem retainer from the slots in the stem
port in the manifold
5. Remove the stem retainer and valve-stem seat from the
manifold (Figure 118
6. Reach into the manifold body and remove the
valve-stem assembly
7. Clean the inside of the manifold and exterior of the
ball valve, valve-stem assembly, stem capture, and end
fittings.
56
Figure 119
7. End cap O-ring (0.796 inch
/ 0.139 inch)
8. Back seating O-ring (0.676
inch / 0.07 inch)
9. Ball seat
10. Manifold body
11. Ball valve
12. End-cap-fitting assembly
117).
(Figure 118 and Figure
and Figure 119).
(Figure 118 and Figure
PEN
119).
119).