Installing The Supply Hoses To The Boom Sections - Toro Multi Pro 1750 Installation Instructions Manual

Figure 80
1. Retainer
2. Quick-connect fitting
(left-boom-section valve)
3. Quick-connect fitting
(center-boom-section
valve)
4. Quick-connect fitting
(right-boom-section valve)
3. Secure the straight barbed fitting to the quick-connect
fitting with the retainer that is supplied with the hose
(Figure 80).
5. Straight barbed
fitting—supply hose for the
left-boom section—2 x 205
cm (3/4 x 80-13/16 inches)
6. Straight barbed
fitting—supply hose for the
center-boom section—2
x 58 cm (3/4 x 22-13/16
inches)
7. Straight barbed
fitting—supply hose for
the right-boom section—2
x 170 cm (3/4 x 66-13/16
inches)
Installing the Supply Hoses to the
Boom Sections
1. Assemble the center boom-supply hose onto the
T-fitting at the center-boom section
1. Center boom-section valve 4. Supply hose (center-boom
2. Center-boom section
3. Left side of the machine
2. Secure the hose to the T-fitting with a hose clamp that
you removed in step
Hoses (page 11).
3. Route the right boom-supply hose through the support
clamp at the end of the center-boom section
82).
39
(Figure 81).
Figure 81
section)
5. Hose clamp
6. Barbed T-fitting
5 of Removing the Boom-Section
(Figure