GE AxiChrom 50 Operating Instructions Manual page 127

6 Maintenance and service
6.2 Performing maintenance and service
Continue until the O-ring has come into contact with the top of the wall of the
scraper seal [605].
Figure 6.15: Placement of the O-ring onto the distributor.
d Use the O-ring mounting tool to push the O-ring into the groove created by the
scraper seal and the wall of the distributor. Press down one part of the O-ring
and then at an opposite point on the O-ring circumference. Continue until the
O-ring is located within the groove.
Figure 6.16: Location of the O-ring into the groove of the scraper seal.
AxiChrom 50, 70 and 100 columns Operating instructions 28-9331-08 AG 127