GE AxiChrom 50 Operating Instructions Manual page 132

6 Maintenance and service
6.2 Performing maintenance and service
Reassembling the plastic bottom bed support
1 Fit a new O-ring [606] onto the distributor [404].
2 a For 50 and 70 columns:
132
NOTICE
Always wear gloves when handling the bed supports, distribu-
tors and bed supports to prevent the transfer of fats and other
contaminants from your fingers.
Place a new bed support in the snap ring. Place a new support net on the distrib-
utor. Fit the bed support and snap ring assembly onto the distributor. Ensure that
the edge of the support net is not trapped by the snap ring and that the bed
support is in contact with the distributor all around the circumference.
Note:
Check that the snap ring is correctly and evenly mounted around the
whole circumference of the distributor.
Figure 6.22: Fitting the bed support in the snap ring and the snap ring onto the
support net and distributor (50 and 70 columns).
b For 100 column:
Place a new bed support in the snap ring. Fit the bed support and snap ring as-
sembly onto the distributor. Ensure that the bed support is in contact with the
distributor all around the circumference.
Note:
Check that the snap ring is correctly and evenly mounted around the
whole circumference of the distributor.
AxiChrom 50, 70 and 100 columns Operating instructions 28-9331-08 AG