3.5.3
Installing an S120 Combi Power Module
An S120 Combi Power Module is installed after the reinforcement plates have been installed.
Installation steps
1. Mount the M6 self-clinching flush head studs
2. Locate the S120 Combi Power Module
3. Initially tighten the M6 nuts by hand (0.5 Nm).
4. Tighten the nuts in the specific sequence (1 to 4) with 10 Nm
Figure 3-16
Installing an S120 Combi Power Module
SINAMICS S120 Combi
Manual, Edition 05.2010, 6SL3097-4AV00-0BP0
S120 Combi Power Modules
3.5 Installation
95