3.6.3
Signal cables at the EP terminals
The shields of the signal cables at the EP terminals X21 and X22 are connected using the
shield clamp
involves the following steps:
● Mount the shield clamp at the S120 Combi using an SW3 wrench with a tightening torque
● Strip the insulation from the signal cables and crimp on end sleeves to the individual
● Connect the cores to the EP terminals (screw terminals)
● Connect the signal cable shields as shown below.
SINAMICS S120 Combi
Manual, Edition 05.2010, 6SL3097-4AV00-0BP0
①
from the Completion Kit (Weidmüller: KLBÜ 4-13.5). The connection
of 1.8 Nm
cores
Figure 3-20
Signal cables connected with the correct shield support
S120 Combi Power Modules
3.6 Electrical connection
99