(2) After the wave pattern is output three times, the wave output stops and the data set in 'CH1 Output setting during wave output stop (Un\G524)' is output in

analog.

The following section describes "repeat control" in which the same wave pattern is output repeatedly from the D/A converter

module.

■When the digital values are same for the start point and the end point

An end point of a wave pattern overlaps with the start point of the wave pattern of the next iteration in the D/A converter

module's processing; therefore, the end point is not output in analog. The analog output of the wave pattern end point varies

as follows depending on the setting of 'CH1 Wave pattern output repetition setting' (Un\G530).

• Limited repetition:

When a value of 2 to 32767 is set to 'CH1 Wave pattern output repetition setting' (Un\G530), the digital value of the end point

is not output in analog till the wave pattern of the final iteration output. After the digital value of the end point is output in analog

at the wave pattern of the final iteration output, the value is output in analog according to the setting in 'CH1 Output setting

during wave output stop' (Un\G524).

• Unlimited repetition:

The digital value of the wave pattern end point is not output in analog.

The digital values are

same for the start point

and the end point

1 cycle

A wave pattern that is

repeatedly output in analog

(1) In the limited repetition, after the value is output for the count set in the wave pattern output repetition setting, the analog value set in the output setting

during wave output stop is output.

(2) The value at the start point of the next repetitive wave always comes after the value at the end point of the previous wave. Preventing the output of the value

at the end point allows the wave to be connected seamlessly.

1st time

2nd time

Analog output

1 cycle

(1)

3rd time

(2)

1 cycle

(2)

(1)

1 FUNCTIONS